3
OM-BLAST CHILLER
USB FLASH DRIVE
Data stored from previous blast chiller cycles and alarms can be retrieved from the
controller’s internal memory and sent to a USB flash drive. This makes for a convenient
method to transfer blast chiller data to a personal computer. Data is written into a file
on the flash drive in a comma delimited form that is suitable for text and spreadsheet
applications. A data transfer to a USB drive is initiated as follows:
1. Access Control MENU from the home screen.
2. Enter the control panel by pressing Control Panel button.
3. Select Log File Management.
4. Insert USB drive into USB port on front panel of unit.
5. Select file to export and follow prompts.
6. Once complete the door button in bottom right corner of the screen will take
you back a page until you get back to the home screen.
QUICK START GUIDE
MAINTENANCE
WARNING: DO NOT USE SHARP UTENSILS AND/OR OBJECTS.
WARNING: DO NOT USE STEEL PADS, WIRE BRUSHES, SCRAPERS, OR CHLORIDE
CLEANERS TO CLEAN YOUR STAINLESS STEEL.
CAUTION: DO NOT USE ABRASIVE CLEANING SOLVENTS, AND NEVER USE
HYDROCHLORIC ACID (MURIATIC ACID) ON STAINLESS STEEL.
WARNING: DO NOT PRESSURE WASH EQUIPMENT AS DAMAGE TO ELECTRICAL
COMPONENTS MAY RESULT.
Unified Brands strongly suggests a preventive maintenance program which would
include the following monthly procedures:
NOTE: When cleaning the interior cabinet place unit into standby mode to prevent
door alarm from becoming active.
MONTHLY PM PROCEDURES
1. Cleaning of all condenser coils. Condenser coils are a critical component in
the life of the compressor and must remain clean to assure proper air flow and
heat transfer. Failure to maintain this heat transfer will affect unit performance
and eventually destroy the compressor. Clean the condenser coils with coil
cleaner and/or a vacuum, cleaner and brush. NOTE: Brush coil in direction of
fins, normally vertically as to not damage or restrict air from passing through
condenser.
2. Clean fan blade on the condensing unit.
3. Clean and disinfect drains with a solution of warm water and mild detergent.
4. Clean and disinfect drain lines and evaporator pan with a solution of warm
water and mild detergent.
5. Clean all gaskets on a weekly if not daily basis with a solution of warm water
and a mild detergent to extend gasket life.
