Replacing modules:
When exchanging modules, simply turn
both thumbscrews to the left until they fill loose.(Do not
remove the screw completely). Remove the module pulling
out on the thumbscrews. Slide in a new module, and push in
on the center knobs until flush with the front panel. Tighten
the thumbscrews, by turning to the right until snug.
Quick start guide:
Hooking up your gear:
After plugging in the AC power cord, connect a 1/4” instrument cable from the pre or post loop output to the input of your power amp. If
your using your effects loop, use only the post loop output. If you have the foot controller(optional), connect the foot controller to the
MIDI In on the rear panel. After turning on the unit, plug your guitar into the front panel input. Select the desired preamp module, and
adjust each level to 12 o’clock to start. Slowly bring up the master level until your reach the desired volume level. Then adjust the EQ set-
tings on the module to your desired setting. Select the next module and repeat this process.
Channel Switching:
If there are four preamps installed, pressing & releasing the channel select switch will change the channel from 1 to 2, pressing &
releasing again 2 to 3, and again 3 to 4.
Saving a Preset:
Pressing and holding the channel select switch for 2 seconds will store your current settings. When used with the foot controller, select
button 1 on the foot controller, then set to channel 1 using the front panel channel switch button. (both the footswitch and channel 1 light
should be lit). Press and hold the channel select switch for 2 seconds, and this will store your current settings with the footswitch. The
footswitch will not select any preferred channel. To reset, simply turn the preamp off/on, and repeat the above steps.
Summary of Contents for RM100
Page 1: ...F I E R S 100 TUBE HEAD M A N U A L...
Page 12: ......
