ASSEMBLY INSTRUCTIONS
1. The fan has 3 wires connected to the tip of fan motor.
┄
Grounding wire
┄
power wires
2. Making sure the down rod is locked with setscrew.
3. Mount the fan blades on the motor with lock washer and screw.
4. Make wiring connections with regulators as shown on fig.2.
5. Slide the canopy up to the ceiling and tighten the screw.
6. Turn on the power and your fan will be ready for operation.
7. A contact separation of at least 3mm in all poles should be provided
in the fixed wiring for disconnection purpose.
2
GENERAL
After opening the box, you should find the following parts.
┄
one fan motor
┄
one down rod
┄
one regulator
┄
one set of blades
┄
two ceiling canopies
----two mat slices
----two openings sells
----two spring coil washers
----two hexangular nuts
----two hexangular stud bolt
Tools required
┄
pliers
┄
standard screwdriver
INSTALLATION INSTRUCTIONS
1. Before beginning, disconnect power by removing fuse or turning off circuit
breaker.
2. It is essential that the structural member from which the fan is to be
suspended will safely support the fan. In view of the torque and weight
factors involved. Some hangers will require additional strength by securing
more firmly to wood beams or steel supports.
3. Screw hook through center of hanger into beam or ceiling.
Fix Fork Pipe to the motor shaft. Tighten the bolt and nut firmly.
Make sure the cotter pin is inserted and bent.
4. Tie the safety wire as shown in Figure 1
～
5 and screw safety wire to the
pipe firmly.
5. Safety wire must be tied to ‘U’ hook or ‘J’ hook.
6. Assembly the other end of the pipe with the pulley to the ceiling hook.
Insert the cotter pin and bend.
