4
Installation
The winch shown in this owner’s manual is solely and ex-
clusively designed for vehicle mounted, non-industrial appli-
cations. All other applications will void warranty.
It is very important that the winch be mounted on a flat sur-
face so that the three major sections (the motor end, the
cable drum, and the gear housing end) are properly aligned.
It is recommended that Ramsey kits be used to mount the
winch. They are designed to align the winch and distribute
up to the full rated load evenly, to avoid possible damage to
the winch or vehicle.
NOTE: If recommended mounting is not used, a kit of equal
design must be used.
Also available for mounting the Patriot 9500 UT are the fol-
lowing winch mounting channels:
• #251126 short length (23.63”) black
• #251127 medium length (30.00”) black
• #251128 long length (36.00”) black
It is recommended that Ramsey mounting channels be used
with all non-Ramsey mounting.
Attach fairlead to channel using hardware furnished with
winch. Attach winch to channel. Thread capscrews with
lockwashers through mounting holes in channel and into
winch feet (see Figure 1).
Substitution of attaching hardware items (bolts, nuts or
washers) different from those supplied with your winch and
mounting kit can lead to failure causing damage or serious
injury (use SAE grade 5 bolts or better and torque to 34
ft.lbs.).
Place end of wire rope through fairlead and attach cable
hook. Use clevis pin and cotter pin (see Figure 1).
TO ENSURE PROPER ALIGNMENT OF
THE ROLLER FAIRLEAD TO THE
DRUM, POSITION SMALLER (7/16”)
HOLES AT BOTTOM FOR MOUNTING.
ROLLER FAIRLEAD
DETAIL A
CONNECT BLACK GROUND CABLE
TO NEGATIVE (-) TERMINAL
OF VEHICLE BATTERY.
CONNECT RED CABLE
TO POSITIVE (+) TERMINAL
OF VEHICLE BATTERY.
SHIFTER LEVER
CLUTCH
CONTROL SWITCH
RECEPTACLE
3/8-16NC X 1-1/4 LG.
FAIRLEAD MOUNTING BOLT
FIGURE 1
(SEE DETAIL A
ROLL PIN
CABLE HOOK
CLEVIS PIN
3/8-16NC X 1-1/4 LG.
ROLLER FAIRLEAD
WINCH MOUNTING BOLT
CHANNEL
MOUNTING
FOR POSITIONING
ROLLER FAIRLEAD)
Summary of Contents for PATRIOT 9500 UT
Page 7: ...7 NOTES...
Page 11: ...11 NOTES...
