SAFETY INTRODUCTION
DANGER
SAFETY INTRODUCTION
DANGER
2
!
Read, understand and follow the instructions in
the tool manual before attempting to use the tool.
!
Operators and Bystanders must wear eye and
hearing protection.
!
Never close tool with hand over the fastener loading
end of the tool. A serious hand injury from penetration
by the piston or fastener could result.
!
The gas in fuel cells is under pressure and the gas
is flammable.
!
Do not open, puncture or burn fuel cells.
!
Store fuel cells in a well ventilated area, at temperatures
below 50° C (122° F) and out of the sunlight.
!
Keep fuel cells away from flames, sparks and heat.
!
Do not attempt to recharge, refill or recycle fuel cells.
!
Never operate the T3 tool if flammable or explosive
materials are nearby.
Just as no one can merely read a book about driving an automobile and then
hope to drive one safely, no one should attempt to use T3 gas powered tools
without adequate, competent personal instruction.
No automobile instruction book or instructor can forewarn a learner against
all possibilities and emergencies, nor can printed material detail all possible
conditions surrounding the use of Ramset tools and products.
Responsibility for the safe and proper use of this tool rests with the tool user
and the employer.
DANGER
THIS TOOL IS TO BE USED ONLY BY PROPERLY TRAINED
OPERATORS. ATTEMPTING TO HANDLE OR OPERATE THE
T3 GAS POWERED TOOL WITHOUT PROPER TRAINING CAN RESULT
IN SERIOUS INJURY TO THE OPERATOR OR BYSTANDERS.
DANGER
