TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
8
TOOL OPERATION
Always check the tool first to make sure
that it does not contain a fastener. If the
tool contains a fastener from a previous
application, remove both the battery and
the fuel cell before attempting to remove
the fastener.
Operating the R150 Tool
1. Insert a charged battery into the tool
with the battery contacts to the front.
2. Insert a good fuel cell into the tool as
described on page 5.
3. With your finger off the trigger, insert
the fastener you wish to use in the
muzzle bushing of the tool. Do not
force the fastener into the tool such
that you cause the muzzle bushing
to be pushed up into the tool body.
4. Note that the LED light on the side of
the handle is a solid green indicating
the the tool is now ready to make a
fastening.
5. Place the tool in the spot where you
want to make your fastening.
6. With the tool in place and the supporting
foot in contact with the work surface,
hold the tool perpendicular and pull
the trigger to make the fastening.
7. The tool is now ready for the next
fastener.
To avoid overheating the tool do not
hold your hand over the air intake
section on the top end of the tool.
Insert battery
Insert fuel cell
Insert fastener
Hold tool perpendicular
In contact with work surface
90°
