Your Ramset D45A Tool uses only the Ramset fasteners and loads shown below or
listed for the tool in the Product Catalog.
FASTENERS
FASTENERS / LOADS
FASTENERS / LOADS
7
Never use any other types of fasteners or disc loads in the Ramset D45A Tool. Use of other
types of fasteners or loads may cause unintentional load discharge, damage the tool, cause
poor fastening performance, or create a risk of serious injury to the operator or bystanders.
DANGER
LOADS
Ramset D60/45 disc loads are specially made for use in the Ramset D45A Tool.
The power level of the load is indicated by
the number marked on each box, the color
of the box, and the color on the tip of each
load. As the number increases, the power
level also increases.
Always perform the center punch test
described on page 3 to test the base material.
Always make a test fastening using the
lowest power level first. If more power is
required to set the fastener, use the next
higher power level until the powder level
necessary to drive the fastener is reached.
D60/45
DISC LOAD
POWER CATALOG LOAD CASE
LEVEL NUMBER COLOR COLOR
2
2D60 Brown Brass
3
3D60 Green Brass
4
4D60 Yellow Brass
5
5D45
Red Brass
.300 HEAD PLASTIC FLUTED DRIVE PINS
.145 Shank Diameter in Shank Lengths from
1/2” to 2”
.300 HEAD PLASTIC FLUTED DRIVE PINS
WITH 7/8” WASHER
.145 Shank Diameter in Shank Lengths from
1” to 2-1/2”
.300 HEAD POWER POINT
PLASTIC FLUTED DRIVE PINS
.150 Straight Shank in Shank Lengths
from 1/2” to 7/8”
.150 /.180 Step Shank in Lengths
from 1” to 1-7/8”
CEILING CLIP ASSEMBLIES
Ceiling Clip with 1” or 1-1/4” premounted
.145 Shank Pin and Ceiling Clip with 7/8” or
1-1/4” Premounted .150/.180 Shank Pin
1/4” - 20 THREADED STUDS
.145 Shank Diameter in Shank Lengths of 1/2”
and 1” and Thread Lengths of 1/2”, 3/4” and 1”
8 mm HEAD TOP-HAT DRIVE PINS
.145 Shank Diameter in Shank Lengths from
1/2” to 1”
CONDUIT CLIP ASSEMBLIES
For 1/2” and 3/4” Diameter Conduit with 7/8”
Premounted Power Point Fastener
