NOTE: Actual product may vary from illustration.
I-9950919 REV. B
March 2020
Page 5 of 8
Installation Steps
11
10
9
8
Insert bearing race of NSK Bearing (small) into the top of the tube by tapping evenly all around the edge.
Note: Make sure tapping evenly the bearing race all around the edge and fully seated into the housing.
Place the Swing Away onto the pivot on the bumper.
Pack the NSK Bearing (small) with Marine-Grade grease.
Insert the NSK Bearing (small) and place Pivot Flat
Washer in the house, on the Pivot and into the Race.
Thread on the Castle Nut. Tighten the Castle Nut by hand as far as you can while pivoting the Swing Away. This will
help make sure the bearings are properly seated. Then, using a 36mm Socket, tighten the castle nut as tight as it will
go. Then back off the Castle Nut until the slots align.
Pivot the swing away through the full range of motion to make sure it moves smoothly
