5.
Fixture of the table top
The table can be fixed against movement in two ways.
Using dowels (A) on the rails of the saw horses and using
4 6x90 mm screws (D) with a shaped washer (H) and wing nut (F). Fixation with screws is particularly
necessary if the table is to be used to process heavy material. This fixation prevents the board from
Fixing the table top with the dowels (A) prevents its
movement on the saw horses and ensures it is correctly
mounted on the saw horses.
The installation is now finished and the
table is ready.
WHATEVER, WHEREVER,
WHENEVER.
Fit the wooden jaw (2) on the spindle guide and rotate it onto the already installed spindle body.
Fully tighten the wooden jaw (2) with the spindle and ensure that it is horizontal with the table top.
After this, fix the
wooden jaw with 6x40 mm screws (B3) to the spindle guide.
4.
Installation of the handle in the spindle
On one end of the handle, fix the end with the dowel (A) and glue (J).
Insert it into the spindle and glue the second
end on the other end. Wipe excess glue off with a rag. Leave to dry for at least one hour before use.
B3
B3
A+J
H
F
D
Ramia s.r.o., Zátaví 58, CZ-397 01 Písek, Czech Republic, , Tel: +420 382 264 450, fax: +420 382 264 450, www.ramia.cz
