RAMBO R750, Owner'S Manual, Page: 11 / 25

10
• Remove the adjusting nut from the quick
release skewer. Remove the cone spring next to the
tension adjusting nut as shown in Figure 3.1.
• Slide the skewer through the hollow hub axle
of the wheel so that the quick release lever will be on
the right side of the bike when the wheel is installed
as shown in Figure 3.2
• Place the cone spring that you removed back
onto the skewer. The small end of the spring should
be facing the hub. Thread the tension adjusting nut
onto the skewer as shown in Figure 3.3
• Place the wheel assembly into the fork drop -
outs being careful to align the brake disc into the
caliper slot as the axle is installed into the fork drop-
outs.
• Move the quick release lever to a position
halfway between the OPEN and CLOSED position
(perpendicular to the bicycle frame). Figure 3.4
Adjusting Nut
Cone Spring
Quick Release Lever
Figure 3.1
Figure 3.2
Figure 3.3
• Turn the tension adjusting nut until it can
no longer be turned by hand and check to be sure
the tension nut is firmly against the fork dropout as
shown in Figure 3.5
• Ensure the axle is positioned correctly in the
forks dropouts.
• Check brake rotor alignment in the caliper
slot. The wheel should rotate freely without the cali-
per rubbing or binding.
• The tire should be an equal distance from
each side of the fork.
• Move the quick release lever to the CLOSED
position as shown in Figure 3.6.
• Be sure the quick release lever is all the way
to the CLOSED position.
Figure 3.4
Figure 3.5
Figure 3.6