10
ANCILLARY SERVICE INFORMATION
MAINTENANCE
Allow the cooker to cool after use before performing any cleaning or maintenance work. Do
not move the appliance or attempt any maintenance within 30 minutes of cooker being used.
Burner ports may be cleaned with either compressed air or pipe cleaner or similar device.
Any spider’s web formed in the burner inlet (venturi) must be cleared with a pipe cleaner or
similar length device. Caution: Operation of the burner with a web in the inlet may result in
leakage and/or ignition of gas at the burner inlet.
It is also recommended that the hose assembly and regulator inlet fitting seals be checked
for damage, abrasion, cracking or displacement before each use. Hose assemblies may
harden with age and should be replaced if this occurs. If a replacement part or assembly is
required please contact place of purchase or an authorised agent for advice.
Periodic service should be performed at intervals not exceeding 6 months by an authorised
service agent or more often if required
Keep the appliance clean regularly by wiping with a damp cloth.
Before checking and maintaining the cooker, make sure the main gas valve is turned off.
Make sure the burner head(s) is/are clean before using the cooker. Use a steel wire brush to
clean the burner if it is heavily clogged. If the burner is heavily clogged, do not use the unit.
Contact your authorised plumber or gas fitter to carry for cleaning and maintenance. Do not
attempt to remove the burner unit(s) yourself.
Check the gas hose regularly for wear or leaks. If any wear or leaks are presents, please
contact an authorised plumber / gasfitter for repair.
Do not touch the burner, trivet, tray etc. immediately after use or when in use. This could
burn your hand.
Clean the bowl after each use. Always wipe off spills, do not leave spills to dry on the
surface of the bowl or burner.
Ensure the burner cap is placed correctly and securely on the burner head.
CORRECT
WRONG
ABNORMAL OPERATION
You should cease using the appliance and seek service from an authorised agent if any of the
following are observed during operation of the appliance:
Carbon build up on the appliance or pans,
Excessive yellow tipping of the burner flame,
Flames lifting off the burner ports or flashing back.
The burner aeration disc is factory set for operation on Propane gas and at the required
supply pressure. Any adjustment of the aeration disc will result in flame abnormality. The
aeration disc is located 3.0 mm before the mouth of the mixing tube. This 3.0 mm clearance
must be maintained.
Summary of Contents for HPA100LPB
Page 13: ...13 ...