RAM CSS205, User Manual, Page: 27 / 36

Value
Value
1. Blank Threshold Filter.
The value "Blanlk Threshold" sets the level when the signal is considered as missing. Threshold varies from -45 to
+15dBu, step 1 dB . When enabled this filter outputs an audio type alarm.
This filter computes RMS level instead of PEAK level.
2. Alarm Delay
This parameter sets the time from the error detection to the "ALARM” on CSS205.
Obviously if the error disappears during that time, the CSS205 will not got to "ALARM”.
Parameter Comment
1 ~ 180 Delay (second)
Alarm delay
WEB INTERFACE - next -
To save the configurations
3. Reset Delay

These value set the time between error disappearance and CSS205 alarm cancellation, and return to the main source.
Should an other error occur during this time CSS205 stay on “ALARM “
Parameter Comment
1 ~ 180 Delay (second)
Reset delay
Value
Parameter Check box Comment
Blank Threshold Enable/disable 0 ~ -60 threshold in dBu
4. Audio Mode
CSS205 runs 4 audio modes :

Left or right, watch over is on both channel. Should an error occur on Left or Right, CSS goes on ALARM

Left and Right watch over is on both channel. Should an error occur on both and only on both Left and Right, C S S
goes on ALARM.

Left, watch over only on left channel.

Right, watch over only on right channel.
Note:
When an audio mode is on the key changes to blue.
Only an audio mode can be on in the same time.
 Setting ( Main and Backup).
27
RAMI RAMI - CSS205