86
GETTING TO KNOW YOUR VEHICLE
Storage Position
The storage position for the bed divider is at the front of
the truck bed which maximizes the bed cargo area when
not in use.
To install the bed divider into the storage position, perform
the same steps as you would for the divider position,
except position the divider fully forward in the bed against
the front panel.
Storage Position
The outboard ends should be positioned in front of the
cargo tie-down loops.
Cargo Tie-Down Loop
TRI-FOLD TONNEAU COVER — IF EQUIPPED
The Tri-Fold Tonneau Cover can be installed on the truck
bed to protect your gear and cargo.
T
RI
-F
OLD
T
ONNEAU
C
OVER
R
EMOVAL
To remove the Tonneau Cover, use the following steps:
1. Open the tailgate to gain access to the rear pair of
Tonneau Cover clamps located on the underside of
the cover.
Location Of Rear Latches
NOTE:
If clamp wire is damaged replace immediately.
2. Pull both clamp handles down to release the Tonneau
Cover’s rear panel.
Released Position
23_DJD2_OM_EN_USC_t.book Page 86
