CAUTION!
•
Always remove the key fobs from the vehicle and
lock all doors when leaving the vehicle
unattended.
•
For vehicles equipped with Keyless Enter-N-Go —
Ignition, always remember to place the ignition in
the OFF position.
NOTE:
Duplication of key fobs may be performed at an autho-
rized dealer. This procedure consists of programming a
blank key fob to the vehicle electronics. A blank key fob
is one that has never been programmed.
When having the Sentry Key Immobilizer system ser-
viced, bring all vehicle keys with you to an authorized
dealer.
GENERAL INFORMATION
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Innovation, Science and Economic Development
Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d`Innova-
tion, Science and Economic Development applicables
aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est sus-
ceptible d'en compromettre le fonctionnement.
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. es posible que este equipo o dispositivo no cause
interferencia perjudicial y
2. este equipo o dispositivo debe aceptar cualquier
interferencia, incluyendo la que pueda causar su
operación no deseada.
NOTE:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
VEHICLE SECURITY ALARM —
IF EQUIPPED
The Vehicle Security Alarm monitors the vehicle doors,
tailgate, and ignition for unauthorized operation. When
the Vehicle Security Alarm is activated, interior switches
for door locks are disabled. The system will turn the
horn off after 29 seconds, 5 seconds between cycles,
up to 8 cycles if the trigger remains active and then the
Vehicle Security Alarm will rearm itself.
TO ARM THE SYSTEM
Follow these steps to arm the Vehicle Security Alarm:
1. Remove the key from the ignition system. Refer to
"Starting The Engine" in "Starting And Operating" for
further information.
○
Make sure the vehicle ignition system is OFF.
2. Perform one of the following methods to lock the
vehicle:
○
Push the lock button on the interior power door
lock switch with the driver and/or passenger
door open.
○
Push the lock button on the exterior Passive
Entry door handle with a valid key fob available
in the same exterior zone. Refer to "Keyless
Enter-N-Go — Passive Entry" in “Doors” in this
chapter for further information.
○
Push the lock button on the key fob.
3. If any doors are open, close them.
The Vehicle Security Alarm will set when you use the
power door locks, or use the key fob to lock the doors.
After all the doors are locked and closed, the Vehicle
Security Light, in the instrument cluster display, will
flash rapidly for about 16 seconds to indicate that the
alarm is being set. After the alarm is set, the Vehicle
Security Light will flash at a slower rate to indicate that
the system is armed.
TO DISARM THE SYSTEM
The Vehicle Security Alarm can be disarmed using any
of the following methods:
1. Push the unlock button on the key fob.
GETTING TO KNOW YOUR VEHICLE
21
2
