RAM 2011 3500 Chassis Cab, User Manual

Page: 15 / 92

• Pass each tether strap hook under the head restraint and through the loop of
webbing behind the child seat.
• Route each tether strap to the anchor behind the center seat, and attach the
hooks to the metal ring.
• Place a child restraint on the center rear seat and adjust the tether strap so
that it will reach under the head restraint to the tether anchor directly behind
the seat and to the anchor directly behind the right seat.
• Install the child restraint and remove the slack in the tether strap according to
the manufacturer’s instructions.
1. Inner Anchor Strap Ring(s)
2. Snap Hook
3. Tether Strap
4. Passenger's Side Rear Child Seat
5. Rear Center Child Seat
6. Driver's Side Rear Child Seat
Installing The Child Restraint Using The Vehicle Seat Belts
• To install a child restraint, first, pull enough of the seat belt webbing from the
retractor to route it through the belt path of the child restraint and slide the
latch plate into the buckle.
• Next, extract all the seat belt webbing out of the retractor and then allow the
belt to retract into the retractor. Finally, pull on any excess webbing to tighten
the lap portion around the child restraint. Any seat belt system will loosen with
time, so check the belt occasionally, and pull it tight if necessary.
• Route the tether strap to provide the most direct path for the strap between
the anchor and the child seat, preferably between the head restraint posts
underneath the head restraint.
• Attach the tether strap hook of the child restraint to the tether anchor and
remove slack in the tether strap according to the child restraint manufacturer’s
instructions.
NOTE: Ensure that the tether strap does not slip into the opening between the
seatbacks as you remove slack in the strap.
GETTING STARTED
13