442
SERVICING AND MAINTENANCE
4. Disengage the side marker socket by rotating
counterclockwise a quarter turn.
5. Pull the socket and bulb straight out from the
housing.
6. Separate the bulb from the socket without
twisting.
7. Reverse the procedure for installation of new
bulb and covers.
FOG LAMPS — IF EQUIPPED
Please see an authorized dealer for service on LED
and Halogen front fog lamps.
Halogen
See below steps to replace:
1. Reach under and behind the front fascia/
bumper to access the back of the front fog
lamp housing.
2. Disconnect the fog lamp wiring harness
connector from the fog lamp bulb.
Fog Lamp Bulb
3. Rotate the bulb counterclockwise a quarter
turn to unlock the bulb from the housing.
4. Pull the bulb straight out from the housing.
5. Reverse the procedure to install the bulb and
cover.
REAR TAIL/STOP, TURN SIGNAL AND BACKUP
LAMPS
See below steps to replace:
1. Remove the two screws and push pin
retainers that pass through the bed sheet
metal.
Tail Lamp Locations
2. Pull the outboard side of the lamp rearward far
enough to unsnap the two receptacles on the
outboard side of the lamp housing from the
two plastic snap post retainers in the outer box
side panel.
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
1 — Tail Lamp
2 — Fasteners
3 — Push - Pin Retainers
22_DT_OM_EN_USC_t.book Page 442
