→
→
→
→
→
→
→
→
→
→
→
→
→
→
The battery used in the control unit is a Nickel-Hydrogen type, and recycled.
-In case of contact the liquid to clothing or body skin or eyes, wash immediately.
-In case of shortening the operating time or the speed becomes slower, it may means the
replacement of the battery. -
Follow the government or local law for battery disposal. -
The battery used in the control unit is a Nickel-Hydrogen type, a wearable component.
The battery life is limited. Battery capacity decreases little by little as you use it more and
more, and as time passes. Its life varies depending on storage, operating conditions, and
environment. When not in use for a porlonged period, the battery might deteriorate.
Under normal use of the unit and battery charged once a day, it should last 1 year. When
the battery operating time seems to have been considerably shortened, a probable cause
is that the battery has reached the end of its life. For replace it, send to the dealer.
1 Year Warranty. Warranty does not include
misuse or normal wear of consumable parts.
WARRANTY
WARNING FOR BATTERY
Remove dust on handpiece wiping with isopropyl alcohol and avoid
wet inside.
Do not apply the oil to the goods and do not clean with water. The
grease inside of the bearing could melt away due to the oil.
Air cleaning is acceptable but air pressure may affect the handpice or
motor
Use the specified voltage.
Use accessories suitable for this product.
Keep the workplace clean. Debris may cause an accident.
4. SUGGESTION FOR MAINTENANCE
Keep the place around in handpiece clean.
Make sure that the power is off before putting the power plug in the
socket in order to avoid an expected injury due to sudden start.
Keep the handpiece with bits mounted.
Do not put handpiece down before it stops completely.
Be sure to pull out the power cord before moving the control box.
Atmospheric Pressure: 500hPa to 1060hPa
Use the bit conforming to ISO standards
Be careful not to drop the handpiece as it may be damaged or
broken.
In case that it is dropped, check if the bit is bent or if any excessive
heat is generated operating slowly and carefully.
Do not turn on the power of controller while the collet of handpiece
open. Short circuit of the handpiece may occur.
