Vehicle base for the
INSTALLATION INSTRUCTIONS
1. Loosen the front door side and rear door side nuts holding the passenger side seat to the floor board.
2. Remove the front drivers side and rear drivers side nuts holding the passenger seat to the floor board.
3. Prior to lifting the drivers side of the passenger seat upward, note the placement of the seat belt anchor.
This is sometimes located at the inner rear seat frame where it uses the seat stud to hold it in place.
If this is the case for your vehicle, be sure to reposition the seat belt anchor as was done by the factory.
4. Lift the drivers side of the passenger seat upward enough to clear the seat frame studs projecting upward
From the floor board.
5. Place the No-Drill™ base in between the seat frame and seat studs and align the holes in the base with those
Of the base.
6. Once aligned, lower the seat frame back into place, check placement of seat belt anchor, and re-install and
Fully tighten all four of the nuts securing the seat to the floor board.
RAM No-Drill
TM
Seat Bases
Item Number
RAM-VB-136 & RAM-VB-136-SW1
CHEVROLET ASTRO VAN
(2000-2011)
RAM Mounting Systems
RMR-INS-VB-136
RAM Mounting Systems
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
www.rammount.com
[email protected]
