This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
To see more mounting options, visit rammount.com
Phone: 1.800.497.7479
w w w. r a m m o u n t . c o m
While holding (H) nuts in place, attach ball adapter to back
of holder using (G) screws. RAM
®
logo must be facing in the
shown direction. Attach additional (L) screws.
Twist key lock to release
internal slide.
Position (H) nuts in nut pockets,
guiding them in place with a pen.
Note: Top cup may vary
Parts
index
3
4
6
Using (K) screws, attach bottom docking cup to vehicle
dock assembly.
5
Using (K) screws, attach top
docking cup to top slide with
numbers facing down.
M
Insert top slide over internal vehicle dock.
7
9
2
Adhere foam pads to the inside
of top cup. Position evenly on top
cup, and cutting around any open
holes as needed.
1
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
To see more mounting options, visit rammount.com
GDS
®
Locking Vehicle Dock
RPR-INS-GDS-DOCKL-V2
TAB-LOCK™
K
G
J
4x
10x
2x
2x
2x
2x
2x
2x
L
2
3
5
7 9 11 13 15 17 19 21 23 25 27 29 31 33
4
6
8
10
12
14
16
18
20
22
24
26
28 30
32 34
For questions regarding the assembly of this holder, contact us at:
Phone:
1-800-497-7479
Email:
2x
H
N
Note: Ball adapter not included
8
Place (N) nuts into top slide,
aligning with holes in internal slide.
Attach (M) screws from behind the
internal slide. Do not fully tighten
(slides must remain loose).