PLEASE TAKE NOTE OF THE FOLLOWING GUIDELINES
Please read these instructions thoroughly before you begin
the assembly and installation.
Frame and board can be adjusted in height separately and
offer you a lot of flexibility and precision. Take yourself
some time to go through this initial installation process.
The metal parts and the support are heavy and can be
scratched easily if not handled with the required caution.
Additionally pay attention to the high risk of injury for
your feet caused by falling parts! Protect yourself with
the appropriate footwear (hardtoed safety shoes).
Make sure that the overall weight resulting from the
weight of the STOIC metal frame, the weight of the
support plate and your electronic device does not exceed
the load bearing capacity of your piece of furniture.
The STOIC Basis made from stainless steel was cleaned
before shipment to you. For this reason, the stainless steel
frame is only to be touched with gloves. Polished stainless
steel is tarnishing over time. If necessary, clean the frame
with a stainless steel cleaner.
A frame made of powder coated steel is best cleaned
with a damp cloth and a little detergent.
ASSEMBLY
GUIDELINES
ASSEMBLY OF THE STOIC BASIS
Place the metal frame on a soft support to protect the table
top and the frame from scratching.
Start with placing the feet to the basis. The 8 mm machine
screw thread fits to the screw socket fixed on the triangle
console. Fix the
spike feet
with the
M8
nuts from top. The
thread of the spike feet shall poke out of the nuts not more
than approximately 5 mm. Do not fully tighten the spike
feet yet.
Stick the selfadhesive
felt lamination sheet
underneath
the spike support disk.
Place the frame with its four spike feet carefully onto the
spike disks.
Use the spirit level to
adjust
the frame. Spin the spike
threads by use of the 4 mm Allen key and finally tighten
them with the 13 mm wrench.
Insert the four 6 mm
steel spikes
with the tip up into the
frame and fix them only slightly with the
M6
nuts from
below.
Carefully place the
support plate
on the spikes. Before
placing a stone plate, protect the metal by placing soft
cloths over the frame.
Make sure that the 6 mm spikes slide into the spike
receptacles on the underside of the support plate.
If necessary, the spike positions must be corrected by
loosening and shifting.
Use the spirit level to
adjust
the support plate. To adjust the
6mm spikes, remove the support plate.
Finally, fix the 6mm spikes in the final position by tightening
the nut with the 10 mm wrench.
BASIS
