Raleigh Pedelec Impulse, Original Manual

Page: 118 / 206

Original User Manual | Pedelec Impulse 2.0 21
Wheel circumference: You can set the “wheel circumfer-
ence” to any value between
1540 mm and 2330 mm by
pressing the / buttons on the control panel. Tapping
the button confirms your selection and then takes you
back to the menu sub-item display.
A change to the setting becomes necessary, for
example, when you have the tyres on your Pedelec
exchanged for some of a different size. In order
to continue to display the correct data, the new
wheel circumference must be entered.
Shift Sensor: Choose from the following values using the
/ button.
OFF 50 ms 100 ms 150 ms 200 ms 250 ms 300 ms
Confirm your selection by tapping the button.
The Shift Sensor recognises gear shifting and
imperceptibly interrupts the power assist for frac-
tions of a second. This enables you to move more
smoothly and considerably faster through the
gears. The higher the value you set, the longer the
assistance is interrupted for, and the more time
there is for shifting gears.
Climb Assist:
Choose from the following values using the
/ button.
1 2 3 4 5 6 7
Confirm your selection using the button.
You can influence the response time of the power
sensor with the Climb Assist. The lower the value
you set, the less responsive the system becomes.
The higher the value you set, the more dynamic
the system becomes, but beware a yo-yo effect.
Brightness: You can select the following values using the
/ button:
Very bright 50%
45%
40%
35%
30%
Average “Standard”
5%
10%
15%
Very dark 20%
The change in brightness is implemented immediately.
Pressing the button confirms your selection and then
takes you back to the menu sub-item display.
Language: You can choose to have the information shown
on the display in the following languages:
•
Deutsch
•
English
•
Francais
•
Nederlands
•
Espanol
•
Italiano
•
Suomi
•
Dansk
You can select the relevant language using the / but-
tons. Tapping the button confirms your selection and
takes you back to the menu sub-item display.
Unit: Under the item “Unit”, you can choose whether in-
formation on distance travelled and speed is displayed
in kilometres (km) or miles (mi). Use the / buttons to
choose between kilometres (km) or miles (mph). Tapping
the button confirms your selection and then takes you
back to the menu sub-item display.
7.4.4.2 Drive
Choose from the following using the / button:
•
Wheel circumference
•
Shift Sensor
•
Climb Assist
•
Back
Confirm your selection by tapping the button. You are
taken back to the menu sub-item display.