Front
Panel
Assembly
Suggestion:
You may want to place a towel on your work surface to ensure that you don’t scratch the
panel.
————————————————————————————
1.
Notice that the Power-On LED has one lead that is longer than the other. This identifies the
functions of the leads – the longer lead is the anode and the shorter lead is the cathode. You
will now shorten both leads while keeping the length distinction.
•
Cut the shorter lead on each LED to be ¼” long
•
Cut the longer lead on each LED to be
⅜
” long
2.
Mount the Power-On LED in its hole and secure it in place with a drop of adhesive.
3.
Install the Power on/off switch in its location on the right end (from the front) of the panel
using the supplied nut. Tighten the nut snug but be careful to not over-tighten the nut because
the thread is plastic and it may strip.
4.
Install the ribbon cable in the connector on the Analog Select board. Orient the cable so that
it goes away from the switch.
5.
Install the input select switch and PC board in its location on the left end (from the front) of
the panel. Orient the PC board such that the cable is on the bottom. Tighten the nut snug but
be careful to not over-tighten the nut because the thread is plastic and it may strip.
6.
Install the volume control in the remaining hole.
————————————————————————————
22
