Raisecom
iTN201-R (C) Hardware Description
5 Fiber and cables
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
51
Interface
Cable
Description
1PPS+TOD (1)
Not equipped
You can make it according to the clock PIN.
1PPS+TOD (2)
Not equipped
You can make it according to the clock PIN.
1PPS
Not equipped
The local end connector is equipped with the type
of 50Ω-long BNC header-straight-female
interface/RoHS. You can make the cable by
yourself.
The clock cable is not delivered with the iTN201-R. You can make or order one as
required.
5.5 Configuration cable
5.5.1 Introduction
The configuration cable is used to connect the Console interface on the iTN201-R to the RS-
232 serial interface on the maintenance console, transmitting configuration data. You can
debug and maintain the local device through the Console interface on the maintenance
console.
The connectors at both ends of the configuration cable are as below:
USB: connecting the USB Console interface
USB: connecting the USB interface on the maintenance console
Before accessing the iTN201-R through the USB interface, install the driver on the
PC for converting the USB interface into the Universal Asynchronous
Receiver/Transmitter (UART) interface. To download the driver, visit
http://www.raisecom.com.cn/support.php and then click USB_Console_Drive.
5.5.2 Appearance
Figure 5-8 shows the appearance of the configuration cable.
Figure 5-8
Configuration cable
5.5.3 Wiring
Table 5-10 shows terminal PINs and wiring.
