www.raisecom.com
User Manual
9
module
USFP-GB/SS15
1000M, single-strand, transmitting distance S1, transmitting
wavelength 1550nm, receiving wavelength 1310nm, SFP optical
module
4.2 Device installation
4.2.1 Environment requirement
There are heat exhaust outlets on both sides of ISCOM2828F switch. Please leave space on both
sides of the switch to keep air flow unblocked. Please make sure the outlets are not blocked.
4.2.2 Install the device on to a rack
To set the switch firmly into a rack, please fix the installation tray to the switch using the four screws
come with the device and fasten the installation handle on to the rack.
4.2.3 Grounding
To ensure the safety of the device and the operator, please make sure that the grounding terminal is
well connected to the earth.
4.3 The connection of the switch
4.3.1 Connect to console
ISCOM2828F switch provides a RS-232 interface in the form of RJ-45 as the CONSOLE interface.
After connecting the CONSOLE interface of ISCOM2828F switch to the serial port on the PC using
the provided cable, users can configure and manage the switch through PC.
1)
CONSOLE interface signal definitions of the switch
The CONSOLE interface of ISCOM2828F is in the form of RJ-45. The RJ-45 connector and jack
and the corresponding pin number is shown in the figure below.
RJ-45 Connector
RJ-45 Jack
The corresponding pin function definition of ISCOM2828F CONSOLE interface is shown in the
table below:
