Raisecom
Gazelle S1512i-PWR (A) User Manual
3
Interfaces and modules
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
16
Parameter
Description
Duplex mode
Support full duplex and half duplex modes.
Specifications
When the transmission rate is 10/100 Mbit/s, we recommend
using the Cat 5 or better STP cable.
When the transmission rate is 1000 Mbit/s, we recommend using
the Cat 6 or better STP cable.
3.1.3 RJ45 Console interface
Table 3-3 lists parameters of the RJ45 Console interface.
Table 3-3
Parameters of the RJ45 Console interface
Parameter
Description
Connector type
RJ45
Duplex mode
Duplex UART
Electrical feature
RS-232
Baud rate
9600 baud
Data bit
8
Stop bit
1
3.1.4 Alarm output interface
The alarm output interface is embedded with an electromagnetic relay. When the Gazelle
S1512i-PWR is in abnormal status, it can output alarms by controlling the connection status
of PINs, notify on-site maintenance personnel, and send alarms to the NMS.
The alarm output interface and power interface of the DC power model is co-located on an 8-
pin Phoenix connector with spaces of 5.08 mm, of which the alarm output interface takes up 3
PINs, as shown in Figure 3-1.
When an alarm is generated, PIN 1 and PIN 2 are connected, and thus the ALM LED is
on.
When no alarm is generated, PIN 2 and PIN 3 are connected, and thus the ALM LED is
off.
