8
Installing Plastic Rolls
To install plastic rolls, place feed roll on top of rollers (A) and spare roll
on rollers (D). Pull end of plastic down between rollers and in front of 2”
roller (B). Next feed it between the 4” green and 3” silver rollers (C). See
illustration below.
Make sure plastic mulch is between tires and green roller for Auto-Start.
A
B
C
Plastic
Spare
Plastic
Roll
Feed
Roll
Drive
Roller
A
B
C
On The Go Roll Change
When the feed roll is almost empty the spare roll can be started
without stopping. This leaves only a seam across the bed.
1. Adjust the spare roll tension so it can spin freely (page 10).
2. Feed plastic through rollers (D) and pull out approx. 2’ of plastic.
3. Feed wad of plastic through rollers (A) and (C). Plastic will now
be feeding off of both rolls.
4. When feed roll is empty remove core from cradle.
5. Pull cable (E) to release latch.
6. Slowly pull handle (F) forward toward tractor to drop the plastic
roll to the feed postion. After it has dropped push handle back
until it latches.
7. Place new spare roll on top rollers (D).
Caution;
keep fingers clear of spinning rollers.
D
E
D
F
