raindrip.com/weathersmart
Installation & Programming
25
Operate timer as a conventional (non-smart) timer.
1. Press SETTINGS.
2. Press ENTER (do not change DATE).
3. Press ENTER (do not change TIME).
4. Change ZIP CODE to all zeroes. Press ENTER.
5. Press ENTER (do not change WATERING
SCHEDULE method).
Smart mode is now disabled.
To enable Smart mode, repeat steps 1-5 above and
enter your local ZIP CODE as shown on page 12.
Conventional Timer Mode Notes:
• The ZIP CODE indicator will flash slowly as a
reminder the timer is in conventional timer mode.
• Disabling Smart mode will not change WATERING
METHOD or WATERING SCHEDULE program.
• TODAY WATER SAVINGS will display 00%.
• Watering durations will not be reduced seasonally.
• Water savings may not be realized.
Disabling Smart Mode
Connect a conventional two wire rain switch (optional).
1. Mount rain switch per the
manufacturer's installation instructions.
2. Remove rain switch jumper wire.
-Press square plunger down.
-Remove yellow jumper wire.
3. Connect wires from rain switch
to terminal strip.
-Press square plunger down.
-Insert switch wires into yellow
terminal blocks (ignore color of switch wires).
Rain Switch is ready for use.
Examples of compatible Rain Switch:
• Nelson
®
8501 Rain-Trip
™
• Rainbird
®
RSD-CEx
• Hunter
®
Mini-Clik
®
• Hunter
®
Rain-Clik
™
• Toro
®
TRS
raindrip.com/weathersmart
Installation & Programming
26
Rain Switch (optional)
(not required for WeatherSmartPRO™)
NOTE: If the jumper wire is removed
and a rain switch is NOT connected,
then actual watering will NOT occur.