12
ICOP Embedded 386SX PC/104 AIO CPU Module User's Manual
2.3 DiskOnChip/EPROM/Flash
ROM
Disk
Setup a DiskOnChip
®
2000 Flash Disk
Installation Instructions
1. Make sure the ICOP-605X is powered OFF
2. Plug the DiskOnChip 2000 device(s) into its socket. Verify the direction
is correct (pin 1 of the DiskOnChip 2000 is aligned with pin 1 of the socket)
3. Set address for both DiskOnChip and Flash Disk devices as below
instructions:
Step1: Enter to AMI BIOS Setup Utility while system power on
Step2: Enter to “Advanced Chipset Setup”
Step3: Select “GPCS Function” to “Enable”
(For DiskOnChip)
Step4: Setect “GPCS0 Command” to “MEMR/W 8bit”
Step5: Select “GPCS0 Start Address” to “0C8000 HEX”
Step6: Select “GPCS0 Size” to “8 KBYTE” (goto Step 10)
(For Flash Disk)
Step4: Setect “GPCS0 Command” to “MEMR/W 8bit”
Step5: Select “GPCS0 Start Address” to “0E0000 HEX”
Step6: Select “GPCS0 Size” to “64 KBYTE”
Step7: Select “GPCS1 Command“ to “IOW 8bit”
Step8: Select “GPCS1 Start Address” to “000100 HEX”
Step9: Select “GPCS1 Size” to “2 BYTE”
Step10: Save changed and exit.
4. Power up the system
5. During power up you may observe the messages displayed by the
DiskOnChip 2000 when its drivers are automatically loaded into system’s
memory
6. At this stage the DiskOnChip 2000 can be accessed as any disk in the
system
7. If the DiskOnChip 2000 is the only disk in the system, it will appear as
the first disk (drive C: in DOS)
8. If there are more disks besides the DiskOnChip 2000, the DiskOnChip
2000 will appear by default as the last drive, unless it was programmed as
first drive. (please refer to the DiskOnChip 2000 utilities user manual)
