3
/
5
Power/Data cable:
In order to guarantee a reliable operation, we strongly recommend the use of our Rainbow
Power/Data cable. This XLR4 pole cable contains two lines á 0,38 sqmm for the transmission of the
DMX signals, as well as two lines á 2,08 sqmm for the supply voltage of the Colour Changers. The
high cross-section of the live wired lines considerably increases the maximum cable length, which you
can use within the system. In order to ensure a reliable operation, you should not use more than
300
m
total cable length (theoretical figure) per output. Please note that you have to differentiate between
the theoretical cable length and the actually usable cable length.
Example:
1.
Actually usable cable length: 145 m (see systemdrawing)
2.
Theoretical cable length: 290 m (please see calculation chart below):
Colour Changer no. 1 =
50 m
=
50 m
Colour Changer no. 2 =
50 m + 45 m
=
95 m
Colour Changer no. 3 =
50 m + 45 m +50 m
=
145 m
Total theoretical cable length in this drawing
=
290 m
(You have to add the total cable length between each Colour Changer and the PSU in order to
calculate the theoretical figure.)
Control-displays:
The Maxi 4 PSU has 2 control LEDs, which are situated on the same side as the sockets:
The red LED shining permanent indicates that the 24 V DC supply is OK.
When the “termination“-switch is activated, the red LED is flashing.
The green LED indicates that a DMX signal is present at the XLR5pol. input.
The Micro PSU has three LEDs:
The yellow LED indicates that the “termination“-switch is activated.
The red LED shows, if the 24 V DC supply is OK.
The green LED indicates that a DMX signal is present at the XLR5pol. input.
Colour Changer 1
Colour Changer 2
PSU
XLR 4 output
Return soc ket
50 m
45 m
50 m
Colour Changer 3
Summary of Contents for Micro Series
Page 1: ...Power Supply Units PSU Short Reference...
Page 8: ......
