8-Lite Plus Manual
6
Revision 1 - Printed
April 10, 1997
11. Move the scroll back to the full point by setting the Mode to D and controlling
the speed on the Frames switch.
12. Use the Range Trim potentiometer to accurately set the end position of the
scroll. This position is correct when the final seam is aligned with the outer
edge of the Rainbow.
13. Set the Mode/Frames switch on the PlusCard to the required setting
The scroll is now correctly installed with a scroll and trimmed. From experience,
we suggest that you:
i
Run the colour changers end to end a few times. This allows the filter to find
its natural position on the spindle. It will also show any noise problems due to
badly made scrolls;
ii
Where many units are to run together, run the colour changers to 95% and
confirm alignment of all units. Retrim where necessary ;
iii
Check the scroll tension at 50% control input; (Mode=E, Addr.=050).
FITTING THE GEL STRING .....continued
