Press Wheel Adjustment
To stretch plastic more or less, turn axles to change the angle of the
press wheels; make in or out adjustment as needed. Press wheels
need to run at the bottom of the trench and not on the side.
Use only high quality plastic to avoid straight line tear.
Press
Wheel
Adjustment
Setting
Changing Plastic Width
1
2
Loosen bolts
(No. 1)
and slide trench openers and roll holders so plastic
roll fits between brackets. Adjust approximately 1½” wider than plastic
width to compensate for the roll’s core.
Remove(for 3’) or add(for 5’) roller extensions
(No. 2)
to make desired
width.
(No.1)
Loosen 4 bolts on each side
to slide assemblies.
(No.2)
Remove (for 3’ plastic) or
add roll (for 5’ plastic)
.
Install
Below
For 5’
Plastic
4
Model 2370 will lay 3’, 4’, or 5’ wide plastic.
