R e m ove battery compartment cover and install two (2) "alkaline"
batteries (not included) in the battery cartridge holder. Match
markings (+/-). Close battery cover on water timer to seal.
Open cov e r . L ow Battery Test runs automatically. LO indicates
defective batteries. When the day SU (SUNDAY) flashes, the batteries
are OK. B egin prog r a m m i n g . Close cover when finished.
STEP 1: BATTERY INSTALLATION
Install batteries. The dial displays 12 :00 AM and the day SU (SUNDAY) flashes at the top of the dial.
Press the MODE key to bring up the clock symbol.
P ress buttons firmly
. Press the DAY/CYC key to display the current day . Press ENTER.
The day stops flashing and the time starts to flash.
Press HR/MIN to select current hour. A dvance to correct hour with AM or PM in upper right corn e r .
Press ENTER.
Press HR/MIN to select current minute. Press ENTER.
Once the clock is set, the current day flashes.
STEP 2: CLOCK SETTING
Table 1 on next page describes watering schedule options. Only one cycle operates at one time.
Choose from 8 programmed watering cycles (see Table 1). Choose watering days of the week in Cycle "-" or
choose a cycle for watering on interval day s.
Set up to 6 start/stop times for active Cycle. E x a m p l e : to water a new lawn in short periods daily, set Cycle
1 for every day with 6 start/stop times.
TO PROGRAM
Press MODE to display the PROG symbol. LCD displays empty schedule as --:--
Press DAY/CYC to set watering frequency. The number on the right side of display next to CYCLE will change.
Press DAY/CYC for desired cycle.
Press ENTER to save cycle content and confirm cycle mode.
If you selected Cycle 1-7, go to Step 4.
STEP 3: SETTING AND CHANGING PROGRAMS
8
NOTE : To prevent corrosion, remove batteries when timer is not in use for long
time periods. Reset clock and programs when batteries are removed for Ionger than one (1) minute.
