Rain Bird WS-PRO2, Installation, Operation, Maintenance, And Troubleshooting Manual

Page: 57 / 113

FIGURE 6-38. Cellular modem mounted inside the WS-PRO2 (power supply not shown)
NOTE:
This installation procedure is for installing the CELL210. The RV50 uses a null modem cable
instead of a ribbon cable and uses a power cable to connect to the SW12 or 12V terminal on
the WS-PRO2.
1. Fasten the mounting bracket to the enclosure using the three screws provided.
2. Thread the smaller SMA connector end of the internal antenna cable underneath the
battery cables and screw it to the RF antenna connector on the cellular modem ( FIGURE 6-
38 (p. 53)).
3. Attach the other end of the cable to the BNC RF bulkhead connector in the lower right
corner of the enclosure. Make sure all connections are tight.
4. Use the ribbon cable to connect the CS I/O port on the CELL210 to the CS I/O 9-pin port on
the WS-PRO2 ( FIGURE 6-38 (p. 53)).
5. The CELL210 is powered from the CS I/O port.
6.7.5.6 External installation of a cellular modem
The antenna should have been ordered with the kit.
NOTE:
Mounting hardware that comes in the box with the antenna will not be used.
Section 6. Installation 53