Rain Bird WS-PRO2, Installation, Operation, Maintenance, And Troubleshooting Manual, Page: 19 / 113

(1) white pole cap
(1) 6 m (20 ft) communications cable (phone or short haul modem)
(1) 6 m (20 ft) power cable (for AC option only)
(1) 6 x 19 mm (1/4 x 3/4 in) hex head self-drilling screw
The pole provides a support structure for mounting the WS-PRO2 weather station components.
The pole is designed to withstand winds of 45 m/s (100 mph). The lightning rod assembly is
attached after the instrumentation enclosure is installed.
Use the following procedure to attach the pole to the base ( FIGURE 6-3 (p. 15)).
FIGURE 6-3. Transparent view shows raising and grounding the WS-PRO2 pole
1. Dig a hole close to the concrete base to access the lower conduit opening.
2. From the hole, trench to the power and communications sources.
3. Remove the duct tape from both ends of the conduit.
4. Remove the template.
Section 6. Installation 15