Additional instructions for connecting a Pump Start Relay.
To avoid possible pump damage
when using a Pump Start Relay,
connect a short jumper wire from
any unused zone terminal(s) to the
nearest zone terminal in use.
For example: if a 4 zone controller
model is in use with only two zones
conected, route the terminals for
Zones 3 and 4 to the nearest active
terminal (in this example, Zone 2).
NOTE:
Make sure that the total draw
of the Master Valve or Pump Start
Relay, plus the draw of the valves
does not exceed 0.650 Amps at
24VAC, 60 Hz.
Jumper Wires
Active Terminal
17
STP Plus Controller
