19
September 2015
The MAXI® Interface Board (ESPMIBL) in the ESP-SATL controller is a circuit board mounted on
top of the output board.
ESPMIBL
Output Board
LINK900 Radio
The LINK900 radio is connected to the ESPMIBL via a 9-Pin serial cable. The LINK900 Radio Kit
for Small Pedestals (H49004) includes an antenna and cable with NMO style mount suitable for
mounting to the top of the controller cabinet. Antennas should not be mounted inside the
controller cabinet itself.
The dip switches on the ESPMIBL need to be set to determine the Group in which the ESP-SATL
will be assigned.
Group 1 = dip 1 on, dip 2 off
Group 2 = dip 1 off, dip 2 on
Group 3 = dip 1 on, dip 2 on
Group 4 = dip 1 off, dip 2 off
Please note that the EPROM Chip in the MIM-LINK / TWI-LINK interface must be of version 10.5
or higher for the Golf central control to recognize an ESP-SATL used with sensors.
Dip Switch bank
for Group setup
Serial connector
for the radio