15
ESP-LXIVM Series Controllers
Connect 2-Wire (MAXI Cable) From
Field Devices
You can connect up to 4 pairs of 2 -Wires (MAXI
Cable) from the field devices back to the ESP-LXIVM
controller.
B
NOTE: Make sure the screws are all unscrewed all the
way out (while remaining in the module)
A
Connect the Red Wire from the MAXI Cable to the
Terminal with “R” marking
B
Connect the Black Wire from the MAXI Cable to the
Terminal with “B” marking
C
Tighten the screw
B
NOTE: The four pair of wires can be either in a Star pat-
tern or a Loop pattern. For details refer to the 2-Wire
Path overview section in the ESP-LXIVM user manual.
Connect Local Weather Sensors
ESP-LXIVM can also accept input from a single
weather sensor wired directly in to the controller.
B
NOTE: Follow the sensor manufacturer’s instructions
to correctly install and make wire connections to the
sensor.
D
Run continuous sensor wires from the weather sensor
to the ESP-LXIVM controller.
E
Remove the yellow jumper wire (if present). Connect
the sensor wires to the sensor (Sen) and common (C)
inputs.
NOTICE
Do not remove the yellow jumper wire unless collect-
ing a rain sensor.
B
NOTE: Ensure that the configuration for your control-
ler and irrigation programs are set up correctly for your
sensor.
R
B
R
B
B
A
E
690715-01_18NO19_LX-IVM field device install guide EN.indd 15
690715-01_18NO19_LX-IVM field device install guide EN.indd 15
1/23/2020 5:41:19 AM
1/23/2020 5:41:19 AM
