Rain Bird ESP-6LX+, Installation, Programming, And Operation Manual, Page: 53 / 73

50 ESP-LX+ & LXi+ Installation, Programming, & Operation Guide
Mount Controller on Wall
The ESP-LX+ has four mounting holes on the back of the
cabinet — three “keyhole” slots at the top of the cabinet and one
circular hole at the bottom of the cabinet. The shipping carton
for the controller contains a mounting template. You may wish to
cut this template out and use it to mark the controller’s mounting
holes in the desired location before you begin drilling.
➊
To install the controller on a flat wall surface, use the left and
right keyhole slots at the top of the cabinet.
➋
To install the controller on a narrow stud, use the center
keyhole slot.
➌
For all installations, use the small round hole at the bottom
of the cabinet.
➍
Hold the controller or mounting template at eye level against
the mounting surface. Use a pencil to mark the position of
the holes on the mounting surface. Then remove the
controller cabinet or template.
➎
On flat wall surfaces, drive an appropriate fastener for the
type of wall into the two outside keyhole marks.
➏
For narrow stud installations, drive an appropriate fastener
for the type of wall into the middle keyhole mark.
➐
Use a nail to tap a small pilot hole on the mark for the
lower mounting hole. However, DO NOT drive a fastener
into this location yet.
➑
Use the keyhole slot(s) to hang the controller cabinet on
the fasteners. Make sure the shafts of the fasteners are well
up in the narrow part of the keyholes.
➒
Drive the last fastener through the lower mounting hole.
Verify that the cabinet is secure. If necessary, tighten the
fasteners in the upper keyhole slot(s).