RAIMONDI BERTA ADV, Manual

Page: 5 / 15

ENGLISH BERTA ADV ELECTROSPONGE
5
Transport
Wind up loose power cables, without knots or kinks.
Never lift or carry the machine by the power supply cable. Never disconnect the machine by pulling the
power supply cable.
Never transport the machine while it is still plugged in.
Unscrew the knobs illustrated in figure 1 and hold down the handle.
To avoid deforming the sponge roller assembly, make sure it is not in contact with the floor and that the wa-
ter dosing lever is released.
Checking before use
Before using the machine, check for any broken, worn or damaged parts and replace them immediately.
For spare parts and accessories, always follow the instructions provided in this manual.
Use only original spare parts.
For the best performance and utmost safety, always keep the machine clean and lubricated.
Always unwind the power supply cord completely and check it for damage.
Before plugging in the machine, make sure the power switch is “OFF”.
Plug the machine into a 230V 10/16A socket. As a precautionary measure, check the information given on
the MACHINE DATA PLATE.
If an extension cord is used, make certain that the section is at least 1.5 mm
2
.
Make sure that the sponge roller is neither warped nor damaged.
Fitting
Make sure that the tank has been correctly fitted.
Raise the handle and lock at the requested height and position,
by tightening the knobs (A) illustrated in figure 1.
F
IG
. 1
A