Railway Equipment 955, Operating Manual

Page: 25 / 82

P/N R9550-0100 25 © 2018 RAILWAY EQUIPMENT CO.
REV I
11/18
Automatic reset
Fault if flame does not go out after gas valve is commanded off
B. SET-UP AND ADJUSTMENTS: To change settings and adjust times do the
following:
Mode Up Push Button
Pushing the Mode Up push button (PB2) will cycle up through the menus. Each
time you press the mode up push button you will advance one menu selection.
Mode Down Push Button
Pushing the Mode Down push button (PB3) will cycle down through the menus.
Each time you press the mode down push button you will move down one menu
selection.
Increase Values
The Increase Values push button (PB4) allows you to increase the values.
NOTE: Values will be saved.
Decrease Values
The Decrease Values push button (PB5) allows you to decrease the values.
NOTE: Values will be saved.
The following is the layout of the controller menu:
Controller Menu
The controller has 4 menu categories, they are:
1. Status
2. Fault History
3. Set Points
4. Factory Defaults
Menu Selection
To select the desired menu, press the Mode Up or Down button until
*****
MENU SELECT ***** is displayed, on line 1, and then use the Increase or
Decrease Value button to select the appropriate menu. Once the appropriate
menu is selected, use the Mode Up or Down buttons to view the contents of the
menu.
NOTE: Use the Increase or Decrease Values button to change setpoint values.