1.1.20 | 1
P: 206.453.1123 | F: 866.802.1690 | railfx.net
RFX-601-KITINST
Kit 601 Series Installation Instructions
for 4x4 Wood Posts
601 Series
Push-Lock
®
Lag
Invisiware
®
Receiver
Stainless Steel washer
for use with wood post
1/8” and 3/16”
1x19 stainless
steel cable
Pre-attached
swaging stud
B. Install Tensioning Terminal
1.
Feed the bare cable through first end post, keeping some of
the cable with the swaging stud available so you can
perform the next step.
2.
Slip the stainless steel washer over the body of the Receiver
and start the swaging stud into the Receiver and turn
3 complete turns. This will thread about 1/2 of the stud
into the Receiver.
3.
Insert the Receiver with the stud into the post.
A. Drill Posts
Hole size for 1/8" dia. cable installation
Hole size for 3/16" dia. cable installation
Tools Required for Installation
• 7/32” Drill Bit
• 5/32" Drill Bit
• 29/64" Drill Bit
• 3" Combo Wrench
• Driver PL-LAG
• 3/16" Alllen Wrench
• RFXPL-KEY
• RailFX Cable Gripper
S/S
Flat Washer
Pre-attached Swaging Stud
7/32”
dia.
7/32”
dia.
5/32”
dia.
5/32”
dia.
7/32”
dia.
1½” minimum
29/64”
dia.
29/64”
dia.
29/64”
dia.
29/64”
dia.
For Intermediate Post
passing cable only
outside of post
outside of post
outside of post
For End Post
using a
R-6-62 Receiver and stud
Hole size for end post using Push-Lock
®
Lag
