Railking E-8 AA Diesel Engine Proto-Sound®2.0
13
Traction Tire Replacement Instructions
Your locomotive is equipped with two neoprene rubber traction tires on each
powered truck block. While these tires are extremely durable, you may need to
replace them at some point.
First, remove the truck sides from the truck block. To do this, turn your engine
upside down. If there are visible Phillips screw heads between the truck frame and
truck block (see below), go to step A. If not, go to step B.
A. Remove the two Phillips screws that attach each truck side to the truck block.
B. Remove the trucks (see page 11) from the chassis and the truck sides from the
trucks in order to slip the new tire over the grooved drive wheel. Once the truck
sides have been removed:
1. Make sure the old tire has been completely removed from the groove in the drive
wheel, using a razor blade or small flathead screwdriver to pry away any remains.
2. Slip the new tire onto the wheel.
You may find it useful to use two
small flathead screwdrivers to
stretch the tire over the wheel.
3. If you twist the tire while
stretching it over the wheel, you
will need to remove and reinstall
the tire. Otherwise your engine
will wobble while operating.
4. Make sure the tire is fully seated
inside the groove. Use a razor blade
to trim away any excess tire that
doesn’t seat itself inside the g roove
properly.
5. Reassemble in reverse order.
One set of replacement tires is packaged with the model. Additional tires are
available directly from the M.T.H. Parts Department (Order online: www.mth-
railking.com, e-mail: [email protected],Fax: 410-423-0009, Phone: 410-381-
2500, Mail: 7020 Columbia Gateway Drive, Columbia MD 21046-1532, ).
Truckside Screws
(Reference Picture Only-
Actual Model May Look Different)
Truckside Screws
