10
RailKing L-1 Mikado Steam Engine
Maintenance:
Lubrication and Greasing Instructions
The engine should be oiled and greased in order to run properly.
You should regularly lubricate all side rods and linkage components and
pickup rollers to prevent them from squeaking. Use light household oil and
follow the lubrication points marked “L” in Fig. 2. Do not over oil. Use only
a drop or two on each pivot point.
The locomotive’s internal gearing was greased at the factory and should not
need additional grease until after 50 hours of operation or one year, whichever
comes first. To access the gear box, do the following:
1. Turn the engine upside down.
2. Remove the Phillips screw (marked “GREASE”) located at the fourth set of
drivers (counting from the front of the engine).
3. Use a grease tube dispenser to put a small amount (approx. 1-2 ml.) of
lithium-based grease into the gearbox.
4. Replace the screw.
You should also grease the trailing locomotive truck tongue to enhance their
ability to slide on the chassis. Follow the grease points shown on Fig. 3.
Lubricate Side Rods and Linkage (L)
Lubricate Pick Up
Rollers (L)
Figure 2. Lubrication Points on the Engine
Grease Pivot Point
Grease Screw (G)
Body
Mounting
Screws
Body Mounting Screws
Figure 3. Greasing Points on the Engine and Body Mounting Screws
