Passenger station announcements (PSA):
Your engine is equipped with a sound package of passenger station announcements that
you can play when you pull into a station.
Each sequence described below will play as
long as it is left on, randomly generating sounds, but be sure to allow approximately
30 seconds between the button pushes described below to allow the PSA sufficient
time to run through each sequence.
!
To cue the sound system to play the PSA, quickly but firmly tap the Bell button once
followed by 2 quick taps of the Horn button while the engine is moving. Tap the
buttons quickly but allow approximately ½ second between each press.
!
Press the Direction button once to stop the engine. This will trigger the first
sequence of PSA. The reverse unit is temporarily disabled so that the train will not
move as you use the Direction button to trigger the sounds, and Proto-Sound 2.0 has
disabled operator control over the Horn and Bell buttons until the full PSA sequence
11
RailKing Genesis Passenger Set with Proto-Sound® 2.0
!
Once the motor mount screw has been removed, pull the
motor away from the truck block and lightly coat the motor
worm gear and bronze drive gear (in the truck block) with
grease.
!
Reassemble the truck and motor, being careful not to pinch
the pickup and ground wires between the truck block and
motor mount.
!
Repeat the procedure if engine has more than one motor.
!
Reassemble the chassis and body, being careful that the
wires are not caught between the body and chassis, as
this can lead to a short that may damage the electronics
beyond repair.
Worm
Gear
Bronze
Drive
Gear
STEP
3
3
!
Remove two screws from below truck side.
!
Remove the truck sides from the truck block.
!
Make sure the old tire has been completely
removed from the groove in the drive wheel,
using a razor blade or small flathead screwdriver
to pry away any remains.
!
Clean the groove using a cotton swab and
denatured alcohol.
STEP
1
1
!
Slip the new tire onto the wheel. You may find it useful to
use two small flathead screwdrivers to stretch the tire over
the wheel.
!
If you twist the tire while stretching it over the wheel, you
will need to remove and reinstall the tire. Otherwise your
engine will wobble while operating.
!
Make sure the tire is fully seated inside the groove. Use a
razor blade to trim away any excess tire that doesn't seat
itself inside the groove properly.
!
Reassemble the truck sides to the truck blocks.
STEP
2
2