GR5640-SB3 User Manual
4
4. Hardware Installation Procedure
Please follow the instructions below to complete the hardware installation.
Open the package and take out the product making sure that all the enclosed contentsare
not damaged or missing. Should you find damages or missing contents, please contactyour
supplier immediately.
Place the system on a stable surface. Ensure that it is well ventilated without blockage tothe
vent and kept away from areas near water and damage prone areas.
Step 1
Step 2
mode, if one hard drive failure occurs, then all data maybe destroyed or lost. If this happens, we
recommend you to consult with a professional hard drive data recovery specialist to see if your
data may be recoverable.
9. When the fan speed switching button is set to "High", the fan will continue to run at full speed.
10. When the fan speed switch is set to "Auto", the fan will run at full speed to accelerate the heat
dissipation if the temperature inside the machine exceeds 50 (± 10%)°C.
11. It is highly recommended for users to back up important data contained within the GR5640-SB3
unit on a regular basis or whenever the user feels necessary to a remote or a separate storage
device. RAIDON will not be responsible for any lost of data caused during the use of the unit or
the recovery of the data lost.
Use the key included in the
accessory kit and inserted into
the key access opening to eject
the removable drive tray latch and
extract the removable drive tray.
Step 3
Step 4 Mount your hard drives onto the removable drive tray and secure it with the screws included
in the accessory kit to avoid any damage to the hard drive due to accidental movements.
Step 5
Step 6
Step 7
Step 8
Step 9
When the hard drive installation has been completed, insert the hard drive tray into the
system horizontally and secure the latch into place.
Connect the AC power cable to the GR5640-SB3, and then plug the AC power to the wall
socket. Boot-up the unit.
Set the storage mode using the LCD and buttons on the front (please refer to section 5 for
front panel and LCD information).
Connect the cable to the PC and the GR5640-SB3 port.
After boot-up, your operating system will automatically detect the storage capacity of your
hard drives. Please follow the operating system instructions to configure and format your
drives. The formatted drives can be configured for the RAID setup.