Raider RDP-ID31, User Manual

Page: 14 / 74

14 www.raider.bg
with a distinct twinge.
8.9. Tools to develop or cornering.
Turntable working instrument can be bent.
After continuous operation with low-speed power
to cool as to leave it idling for approximately 3
minutes with a maximum speed of rotation.
When working with terminals must always use a
universal extension. Use only the cores that are
suitable for heads of screws. Turning to always
place the switch “drilling / hammer drilling» (6) in
position «Drilling».
8.10. Select the direction of rotation. With the
switch (4) you can change the direction of rotation
of power. Rotate right: For drilling and turning the
screw press to switch the direction of rotation (4)
at point blank range left. Rotate left: To develop
the screws and nuts, press switch direction of
rotation (4) right to the point blank range. Switch
(6) the choice of operation should be in position
«Drilling». It must be done to change the direction
of rotation when the spindle rotates a drill!
8.11. Not used in rotation to the left mode of
attack.
8.12. When you need to vent large diameter,
is recommended first to break a small opening,
which will then be drilling to the desired size. This
will prevent overloading the drill. Drilling deep
holes should be done gradually, as periodically
removed from the drill hole to remove chips or
dust. If during drilling to drill holes in zaklini, you
should exclude drill. Use a change of direction
of rotation to remove the drill from the hole. Drill
must be kept in alignment with the hole. Ideally,
the drill should be placed perpendicular to the
surface of the material being processed. If the
condition for perpendicularity is not respected
at work can lead to trapped or breakage in drill
hole and injury to the user. Continued drilling at
low speed the engine from overheating threatens.
Must make periodic breaks during work or to
allow the drill to work on no-load maximum speed
for about 3 minutes. Do not obscure the openings
in the hull used for ventilation of the engine.
8.13. Outdoor use.
Switch the machine only in installations
equipped with electric switch “Fi” RCD (Residual
Current Device). RCD must be no more than 30
mA. Use an extension cord suitable for outdoor
use. Use of a cord suitable for outdoor use
reduces the risk of electric shock.
Make periodic breaks at work.
Keep and refer to the accessories carefully.
Do not throw the tool, do not overload, do not
soak in water and other liquids do not use it for
mixing adhesives and concrete coatings.
9. Service and support.
9.1. Impact drill does not require additional
lubrication or special maintenance. There are no
parts requiring maintenance by the user. Never
use water or any liquid chemical cleaning drill. It
should only be wiped with a piece of dry tissue.
Should always be stored in a dry place and
ventilation holes in the body of the drill to be free.
9.2. Replacing carbon brushes.
Exports (shorter than 5 mm), up or broken
engine carbon brushes should be replaced.
Always replace both brushes simultaneously.
Work on replacement of carbon brushes
entrusted only to qualified person with original
spare parts in service of business RAIDER.
9.3. The repair of your power is best carried
out only by qualified specialists in workshops
RAIDER, which used only original spare parts.
Thus ensuring their safe operation.
10. Environmental protection.
In view of environmental power, additional
accessories and packaging must be subjected
to appropriate processing for reuse of the
information contained in these materials.
Do not dispose of household waste power!
Under the EU Directive 2012/19/EC on scrapped
electrical and electronic equipment and
promoting law and national power, which can be
used more, must be collected separately and be
subjected to appropriate processing for recovery
of contained therein scrap.