14
www.raider.bg
treatment additives (chromate, wood preservative).
Use dust extraction whenever possible.
Provide for good ventilation of the working place.
It is recommended to wear a P2 filter-class respirator.
Insert a vacuum hose onto the extraction outlet (2). Connect the vacuum hose to a vacuum
cleaner. See the overview for connecting to various vacuum cleaners at the end of these
operating instructions. The vacuum cleaner must be suitable for the material being worked.
When vacuuming dry dust that is especially detrimental to health or carcinogenic, use a special
vacuum cleaner.
4.2. Replacing the sanding sheet.
When attaching a new sanding sheet, remove any dust or debris from the sanding plate (4)
(e. g. with a brush). To ensure optimum dust extraction, pay attention that the punched holes in
the sanding sheet match with the holes in the sanding plate. Lightly lift and unlatch the sanding-
sheet clamp (3). Guide the sanding sheet under the opened rear sanding sheet clamp (3) to the
stop and clamp the sanding sheet by reinserting the sanding sheet clamp (3). Fold the sanding
sheet firmly around the sanding plate. Guide the other end of the sanding sheet under the front
sanding sheet clamp (3) and clamp the sanding sheet by reinserting the sanding sheet clamp
(3). To remove the sanding sheet, unlatch the sanding sheet clamp (3) and pull out the sanding
sheet.
Sanding paper must adhere to the sander backing pad. There must be no slack. If the paper
stretches during sanding, remove the slack. It will significantly prolong the lifetime of the
sanding paper.
5. Starting Operation.
5.1. Starting operation.
Observe correct mains voltage! The voltage of the power source must agree with the voltage
specified on the nameplate of the machine. Power tools marked with 230 V can also be operated
with 220 V.
5.2. In the sander is powered by generators that do not have sufficient capacity, respectively
not have appropriate control voltage, to increase the starting current by switching on can be
observed a temporary drop in power or unusual behavior of the sanding machine. Please make
sure you use the generator is appropriate, especially in terms of voltage and frequency.
5.3. Switching On and Off.
Switching on - press the switch button (1) and hold in this position.
Switching off - release pressure on the switch (1).
When finishing polishing, reduce pressure and lift the sander above the processed surface
and only then you can switch off the tool.
5.4. Working advice.
Wait until the machine has come to a standstill before placing it down.
The removal capacity during sanding is mainly determined by the selection of the sanding
sheet as well as the preselected orbital stroke rate.
Only flawless sanding sheets achieve good sanding capacity and extend the service life of
the machine. Pay attention to apply uniform sanding pressure; this increases the working life
of the sanding sheets. Intensifying the sanding pressure does not lead to an increase of the
sanding capacity, but to increased wear of the machine and the sanding sheet.
A sanding sheet that has been used for metal should not be used for other materials.
6. Maintain and service.
6.1. Maintenance and cleaning.
Before any work on the machine itself, pull the mains plug.
For safe and proper working, always keep the machine and ventilation slots clean.
Make periodic breaks at work.
Keep and refer to the accessories carefully.
6.2. Replacing the carbon brushes. Worn-out (shorter than 5 mm), or broken carbon brushes
