Raider RD-PT02, User Manual

Page: 17 / 30

17
indispensable. If wear is noticeable, the cover is swapped.
STORAGE AND MAINTENANCE
General Support:
Check and replace the needle:
The needle is subject to wear, and checking it during cleaning will ensure a long and good operation of
your paint gun. If the tip of the needle has been worn, it needs to be replaced.
CLEANING:
ATTENTION:
Always work with paints, dyes and other chemicals in a correct and responsible way. If you have any
questions about the correct location of each chemical, contact the chemical manufacturer for instructions.
Step 1: Release the vessel pressure and remove the hose.
Step 2: Remove the lid from the paint tank.
Step 3: Clean the paint or the coating from the paint tank. Discard properly.
Step 4: Pour a small amount of clear solvent (as specified by the paint manufacturer) into the container/
tank.
Step 5: Install the cover and tighten until the machine is sealed.
Step 6: Connect the knob to the regulator and raise the vessel pressure.
Step 7: Clean the paint gun by shaking the container and spraying solvent through the spray gun.
Step 8: Repeat steps 1 through 7 until the spraying solvent appears clean and clear.
Step 9: After releasing the pressure from the container, turn off the regulator from the air supply.
Step 10: Remove the lid and discard the remaining solvent at the designated locations.
Step 11: Clean the dish with a clean, dry cloth.
ATTENTION:
For complete cleaning, immerse the container completely in solvent. Do not leave the container in a
solvent for more than 24 hours, as this may cause damage to the container. Never immerse the paint gun
in solvent. When cleaning it, wipe the outside with solvent only.