Raider RD-LM30, User Manual

Page: 16 / 76

16 www.raider.bg
4.8. When cutting close to edges careful not to pinch the mower foreign objects.
4.9. Cutting performance depend on the density, moisture content, length of the grass and the
cutting height. Cutting performance decreases with frequent switching on and off the mower while
mowing. To optimize the performance of the cutting recommended frequent cutting, increasing the
height of the cutting operation and at a moderate speed.
5. Servicing, maintenance and storage.
ATTENTION! Always disconnect the plug from the wall outlet before making activities related to
maintenance or cleaning! Once the machine is off, the blade continues to rotate for some time by
inertia! Before you start working on the mower, wait for the rotation of the motor and the blade to
stop completely!
Never try to stop the rotation of the knife!
When you need to perform operations in the vicinity of the knife, always operate with gloves!
Perform maintenance procedures regularly to ensure your long-term and reliable use of the
mower. Check it periodically for visible defects such as loose or damaged knife and loosened
screw connections. Make sure the covers and guards are undamaged and are installed properly.
5.1. Cleaning.
The easiest way to clean the mower immediately after mowing. After working on the machine
clean thoroughly with a soft brush and cloth. Do not use water and/or solvents and detergents.
Remove all particles of grass, especially from vents. Place the machine on its side and clean the
area of the blade. Always wear protective gloves! Remove firmly adhering particles of wood or
plastic block.
5.2. Sharpening or replacing the cutting blade.
Replace dull or damaged knives. Knife down and unscrew the main bolt in the center of the
blade spanner 27. Before inserting a new blade or after you have sharpened the old one, make sure
the blade is installed properly. Then tighten the bolt again and make sure that no gaps and the knife
is properly installed. Use only suitable for mower blades.
5.3. Always thoroughly clean the mower when to leave it for longer storage. Especially in the
winter. Brush cutter with oil to protect it from rust. When storing the machine for grass basket must
be removed. To save space, you can disassemble the handle. When disassembling and assembling
the top and bottom of the handle careful not to damage the power cord.
6. Faults and correct them.
The table below shows symptoms of failure and how you can help, if your mower stops working
normally. If you can not find and fix the problem by following the instructions in the table, contact
your authorized service Raider. Attention: Before you start troubleshooting, stop the mower and
disconnect it from the mains.
Faults Removal Reasons
Mower does not
start to work
Power cable is not connected or damaged Check cable. If necessary,
replace it.
The engine start
but the knife does
not rotate.
Mower is in a tall grass. Upon initial release always put
the mower in the grass
It is possible that the mower is fuzzy and
the blade is blocked.
Disconnect the plug and
check it. Put on your
protective gloves and clean
the knife and release
Engine is turned off
suddenly.
The power plug is withdrawn
Check cable. Make sure it is
well enshrined in the device
and plug it again.