12
www.raider.bg
5.1. Cleaning.
The easiest way to clean the trimmer immediately after mowing . After working on the machine clean thoroughly with a soft brush and
cloth. Do not use water and / or solvents and detergents. Remove all particles of grass, especially from vents . Place the machine on its side
and clean the area of the cord . Always wear protective gloves ! Remove firmly adhering particles of wood or plastic block .
5.2 . Always clean the main trimmer when leaving it for longer storage. Especially in winter.
6 . Faults and correct them.
The table below shows symptoms of failure and how you can help if you trimmer stop working properly. If you do not find and fix the
problem by following the instructions in the table, contact your authorized dealer Ryder . Attention : Before you start troubleshooting, stop
trimmer and disconnect it from the mains.
Faults
Removal
Reasons
Trimmer does not start to work
Power cable is not connected or damaged
Check cable. If necessary, replace it.
The engine start but the knife
does not rotate.
Trimmer is in a tall grass.
Upon initial release always put the trimmer in the
grass
It is possible that the trimmer is fuzzy and
the blade is blocked.
Disconnect the plug and check it. Put on your
protective gloves and clean the knife and release
Engine is turned off suddenly.
The power plug is withdrawn
Check cable. Make sure it is well enshrined in the
device (14) and plug it again.
Unusual noise.
Bolt of the blade is loose or connections
between fasteners.
Fasten the parts.
Strong vibrations.
Distorted and damaged knife.
Immediately stop the trimmer and replace the knife in
a specialized service.
Unequal mowing. Engine work
hard and reduce turnovers.
The grass is very high.
Increase mowing height.
The blade is blunt.
Replace or tipped knife. .
It is possible that the trimmer is fuzzy and
blocked
Look underneath the trimmer and clean it. Work
always with protective gloves.
The blade can be installed incorrectly.
Check.
If necessary, repair your trimmer is best carried out only by qualified experts in workshops on RAIDER, which used only original
spare parts. Thus ensuring their safe operation.
7. Protection of the environment.
For the environmental protection of the power tool, the electrical appliances and packaging must undergo appropriate
processing for the re-use of the valuable raw materials contained therein. Do not dispose of power tools in household waste!
According to EU Directive 2012/19 / EC on end-of-life electrical and electronic devices and the validation and as a national law,
power tools that can no longer be used must be separately collected and subjected to appropriate processing for the recovery
of the contents making them valuable raw materials.
Product Features:
Product Features:
1. Lever of the switch.
2. Power cord.
3. Electric motor.
4. Handle.
5. Auxiliary handle.
6. Protector
7. Cord spool.
